0

Flood + Freeze Sensor Tampering

  • updated 11 mths ago

The Flood/Freeze sensor has a tamper button on the bottom side of the sensor that will send a tamper signal when pressed.

Most alarm equipment has a built-in tamper switch to deter unauthorized interference. When the panel reports a tamper trouble condition it usually means the sensor casing is loose. This occurs most frequently after changing device batteries.

Troubleshooting Sensor Not Triggering Alarm

  1. Make sure the sensor casing is secure.
  2. Verify that the button at the bottom of the sensor is not being inadvertently pressed (this will cause a tamper)

Related Articles

Recently Viewed

Home