How to Enable Fire Alarm Verification

Enabling Fire Alarm Verification will require the detector to be triggered twice within two minutes, or remain triggered for 30 seconds. By default this setting is turned off, this can be adjusted in the individual sensor settings.

Step By Step Instructions

  1. Tap "Settings" (On the top right-hand corner of your panel)
  2. Enter your Master Code
  3. Select "Sensors"
  4. Select "Smoke"
  5. Select "Smoke/Heat/Freeze"
  6. Select "Edit"
  7. Select the "Fire Alarm Verification" toggle to "On" 

Call 855.268.3669 for additional assistance or you can email Support from the Contact Us page

Was this article helpful?
Reply Oldest first
  • Oldest first
  • Newest first
  • Active threads
  • Popular