1. Charge the Camera
   Open the rubber seal flap on the bottom of the camera and plug in the provided USB-C cable to a power outlet. Allow the camera to charge for several hours until fully charged (up to 6 hours).
2. Turn On the Camera
   Once fully charged, toggle the power switch on the bottom of the camera to the “On” position, then close the flap securely.
   The camera should announce, “Welcome to your new camera.”
3. If You Don’t Hear the Welcome Message
   1. Press and hold the Reset button on the bottom of the camera until you hear “Resetting.”
   2. Wait for the camera to reboot. You should then hear “Welcome to your new camera.”
4. If the Camera Still Doesn’t Power On or Announce the Message
   1. Confirm the camera has been charged for at least 6 hours.
   2. Make sure the switch is set to the “On” position.
   3. Check that the status light turns on when powered.
      1. If there’s no light: Hold the Reset button for 10 seconds until you hear “Resetting Camera.”
      2. Wait up to one minute for the camera to reboot and say “Welcome to your new camera.”

If there is still no light or sound, after checking the above, please contact our support. 

1. Open the Cove Connect App.
2. Tap Cameras → Add Camera.
3. Use your phone’s camera to scan the QR code located on the bottom of the camera.

4. Then tap Wireless Config.

If the app does not find the QR code on the camera: 

• Make sure your camera is in a bright enough area .
• Ensure your phone's camera permissions are enabled. 

1. Enter Your Wi-Fi Credentials
   In the Cove Connect App, enter your Wi-Fi network name (SSID) and password, then tap OK to confirm.
2. Scan the QR Code
   1. The app will automatically generate a QR code on your phone. Hold the Outdoor Camera so it can scan the QR code displayed on your phone screen.
   2. Once the camera successfully scans it, you’ll hear the message: “Wi-Fi settings saved… connecting to the network.”
3. Wait for the Connection
   The camera will now connect to your Wi-Fi network. This may take up to one minute.
4. Complete Setup
   Once connected, the app will confirm a successful pairing.
   You can then name your camera to complete the setup proce

If the Wi-Fi network connection fails: 

• Confirm that your Wi-Fi network is active and you are connected to the correct 2.4 GHz network.
• Ensure the Wi-Fi password is entered correctly (case sensitive).
• Move the camera closer to your router during setup.
• If setup fails repeatedly, reset the camera and router, then retry pairing.

1. Once paired, you should see the live camera feed in the Cove Connect App.
2. You can wave your hand in front of the camera to confirm motion detection and live feed functionality.

Your Outdoor Solar Cam is now successfully paired and ready to use!

• Select a wall, fence, or post with a clear view of the area you want to monitor.
• Make sure the location receives at least 3 hours of direct sunlight each day so the solar panel can maintain and charge the camera’s battery.
• Verify your Wi-Fi signal strength at the installation site by running a speed test on your phone’s browser at speedtest.net.

1. Hold the mounting plate against the surface.
2. Mark the screw hole positions with a pencil.
3. Drill pilot holes (use wall anchors if mounting on brick, concrete, or drywall).
4. Secure the plate using the provided screws.

1. Align the holes on the back of the camera with the notches on the mounting plate.
2. Slide the camera downward until you hear or feel it click into place.
3. Gently tug the camera to confirm it is locked securely.

• Tilt or rotate the camera until you have your desired view.
• Ensure the solar panel is unobstructed and positioned to receive maximum sunlight.