Connecting Your Alarm Panel to Wi-Fi
Your Alarm Panel has the ability to connect to Wi-Fi.
Though not a requirement, connecting your Alarm Panel to Wi-Fi opens up additional features and settings. You can either connect it as its primary network connection or have it as a connection solely for updates.
The Wifi can be connected either during the Setup Wizard or after Installation.
If you are setting up the Wifi during your Setup Process, please refer to this article.
If you are setting up the Wifi After the Installation Wizard has been completed or need to change your Wifi information:
Tap on “More” in the bottom right-hand corner
Tap on “Settings”
Tap on “Touchpad”
Enter your 4-digit master passcode
Scroll down and tap on “Wi-Fi”
Tap on “Primary Network”
Tap on “Change Network” in the top right corner
Select your Wi-Fi Network
Type in your Wi-Fi password
Tap on “Connect”
The Alarm Panel will attempt to make the connection, if you are successful you will see “Success” and you can tap on “Close” and return to your dashboard
Once connected, you will have a display of signal strength and if it’s currently connected to the internet. You can also change the network. If you change the network, click on “Change Network” and follow steps 7-11 to complete changing the network.
If you want to add Wi-Fi only for system updates to the Alarm Panel:
In the “Wi-Fi” settings, click on “Update Network”
Click on “Configure and Select your Network.”
Enter your Wi-Fi password and click “Connect”
On the “Update Network” page, you can check for updates, change the network, or remove the current network.
Note: You must have an available 2.4GHZ network available and The Password for the Wi-Fi network must have at least 8 characters or it will not connect. Please contact your Internet Service Provider if you need any assistance setting up your 2.4GHZ network or updating your Wi-Fi password.
If you have any additional questions about Wi-Fi settings not listed in this article, please reach out to our support team for further assistance.
