Adjusting Your Motion Sensor's Sensitivity

By default, Motion Sensors will not detect warm bodies (including pets) under approximately 30 lbs.

To Adjust Sensor Sensitivity for Pets

1. Open the back of the Motion Sensor
2. Remove the PET pin covering the 55 lbs jumper
3. Place the PET pin on the 33 lbs jumper

Understanding Your Motion Sensor's Sensitivity

By default, Motion Sensors are set to a HIGH sensitivity, so they will be triggered more easily than if set to LOW sensitivity.

To change this setting:

1. Open the back of the Motion Sensor

2. Remove the SENS pin covering the HIGH jumper

3. Place the SENS pin on the LOW jumper

4. It is important to keep in mind, a 10 lb cat 40 feet away from the sensor will not set off the sensor, however, that same cat 10 feet from the sensor will cause the sensor to go off.