Adding your Water Leak Detector

Step-by-Step Guide If you are adding new equipment to your alarm system, make sure you have already added this Water Leak Detector to your alarm system before you install this piece of equipment. Common Installation Locations Behind a toilet Under a sink Under a fridge Beside or behind a washing machine Near a water heater In a basement Locations to Avoid Avoid placing in a location where a child can easily access the sensor Do not place on metallic surfaces or aluminum trays Do not place where water can condense on the sensor Installing Your Water Leak Detector Place the Water Leak Detector in the desired area with the two copper contacts facing down. Using Your Water Leak Detector The Water Leak Detector is designed to detect pooling water as it makes contact across the copper contacts on the bottom of the sensor. It also detects temperatures below 45 degrees that could cause water pipes to burst. These features are designed to provide early detection in the case of a water leak or freezing temperatures.…

Adding Sensor You have the ability to add equipment through the Cove Connect App. Please refer to this article for more information. Please Note: When Adding this Detector you can enroll the sensor to detect water leakage as well as low or freezing temperatures. To do so: Add the Sensor in first as either the Flood or Freeze function After Adding in the sensor as Flood or Freeze, enroll the sensor again with the same serial number and the other function that wasn't enrolled on the first enroll session. Remove Sensor You have the ability to remove equipment through the Cove Connect App. Please refer to this article for more information.…